Paxton OEM Hands free interface, Clock & Data output Instrukcja Użytkownika Pobierz pdf (Strona 2)

Page

Wiring

12V

Red LED

Amber LED

Green LED

Data/D0

Clock/D1

Media detect

Entry

Reader

Entry conrm

12V

Red LED

Amber LED

Green LED

Data/D0

Clock/D1

Media detect

Entry

Net2 Control Unit

Exit/Entry

Green LED

12V

Net2Air Interface

Entry conrmation button

(optional)

Input terminal

(FOR FUTURE USE)

Readers can be extended using Belden CR9540 10-core overall screened cable to a maximum of 100 metres.

Cable extensions

Using an entry conrmation button

Where two door readers may pick up the same hands free token, a push to make button can be used to conrm

an entry request for the specic door. Where tted, the button LED will ash for 5 seconds after the hands free

token has been recognised and must be pressed to unlock the door.

Conguration

Firmware download

Hands free rmware for the P series reader will be downloaded from the interface to the reader as soon as it is

powered up. This is indicated by ashing amber and red LED’s on the reader. Once complete all LED’s will be lit.

This may take up to 10 minutes to complete. Do NOT disconnect power during the rmware update.

If the rmware update is still taking place after 10 minutes then remove and then re-connect the ACU cable.

Listen to the reader, the reader should NOT beep. If the reader beeps within approximately 10 seconds of power

up it will not take the rmware update. Repeat the process until the reader does NOT ‘beep’ on power up. Then

leave for 10 mins to allow the update to take place.

To enable the use of an entry conrmation button do the following steps:

1. Power down the interface board

2. Power up the interface board

3. Press and hold the entry conrmation button for a minumum of 3 seconds within 60 seconds of power up.

To disable the use of the button, repeat the above process.

+12V DC

Red LED

Amber LED

Green LED

Data

Clock

Not Required

1 2 3 4

Komentarze do niniejszej Instrukcji

Brak uwag

Paxton OEM Hands free interface, Clock & Data output Instrukcja Użytkownika Strona 2

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Dla domu Paxton OEM Hands free interface, Clock & Data output